Commonly used route for machining parts on CNC lathes:
(1) Analysis of the path of the arc of the car
In the actual car arc, it is necessary to process multiple knives, first cut off most of the margin, and finally drive out the required arc. The following describes the machining routes commonly used for car arcs.
Figure 1 shows the step path of the arc of the car.
Next page
Author:
Mr. Ellobo Zhang
Phone/WhatsApp:
8615818460968
April 17, 2023
March 13, 2023
(2) Process analysis of parts drawing The analysis and research of the part drawing is mainly to carry out the process review of the parts, such as checking the view of the design drawings,...
The problem of programming in the machining of CNC lathe parts is discussed. First, the programming method Numerical control programming methods are manual programming and automatic programming....
What processing steps do you need to process CNC lathe machining parts? (1) Material and heat treatment requirements The given material and heat treatment requirements on the drawing are the basis...
Email to this supplier
Author:
Mr. Ellobo Zhang
Phone/WhatsApp:
8615818460968
April 17, 2023
March 13, 2023
Send Inquiry
Mr. Ellobo Zhang
Email:
Send InquiryRelated Products List
Mobile Site
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
